Psion Teklogix PrintAbout MP2000 Spezifikationen PDF herunterladen (Seite 27)

Printek Emulation

Load Graphic Image ESC L G n

This command indicates that graphic commands describing an image to be stored is to follow. The value of n is

used to identify this particular graphic image and may be any printable ASCII character (0x21 ≤ n ≤ 0x7E).

This same value is then used to print the graphic.

The graphic data is sent using Graphic commands as described on page

17. The image may consist of up to

2,436 graphic lines. The loading process will terminate when 2,436 lines have been received, or upon receipt

of the Store Graphic Image command.

Example: This escape sequence specifies that the following graphic command(s) will define graphic image

“A”.

Escape Sequence: ESC L G A Graphics Data

Hexadecimal: 1B 4C 47 41 Graphic commands as described on page

17.

Note 1: This command may be used to store graphic images that can later be recalled and printed using

CPCL, ZPL-II, and O’Neil Emulation Easy Print commands. The name used in the Easy Print

command would be “LOGOn”, or “LOGOA” for the above example.

Note 2: As of printer firmware revision 2.8, a special “Print Promo” feature is available that may be enabled

through the printer’s control panel. This feature allows an image that is stored with the value of

n = 0x24 (“$”) to automatically be printed at the end of each print job.

Refer to the Options configuration section in the printer’s operator’s manual for more information.

Note 3: As of printer firmware revision 3.1, a special “Print Header” feature is available that may be enabled

through the printer’s control panel. This feature allows an image that is stored with the value of

n = 0x3F (“?”) to automatically be printed at the beginning of each print job.

Refer to the Options configuration section in the printer’s operator’s manual for more information.

Store Graphic Image ESC L G DEL

This command terminates the Load Graphic Image mode and causes the graphic image to be stored in the

printer’s Flash memory.

After this command is received, the printer will transmit a “D” (Hexadecimal 44) and begin saving the image.

Once the image is stored, the printer will transmit a an Exclamation Point (Hexadecimal 21). The image may

now be printed using the Print Graphic Image command.

Caution: The printer power must remain on throughout this entire process.

Escape Sequence: ESC L G DEL

Hexadecimal: 1B 4C 47 FF

Print Graphic Image ESC L g n

This command will print a graphic image that was previously stored using the Load Graphic Image command.

Example: The following escape sequence will print the graphic logo stored as “A”.

Escape Sequence: ESC L g A

Hexadecimal: 1B 4C 67 41

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 60 61

Keine Kommentare

Psion Teklogix PrintAbout MP2000 Spezifikationen Seite 27